Well another day spent out in the Bullet Barn, I was casting some 45acp 200gr SWC’s and somehow a bullet did not completely clear the mold and it got stuck holding the mold partially opened, it poured and cycled around to the “spure cutting station” and sheared the pin. Anyways got the blockage cleared just in time for the machine casting 200gr 45colt RNFP to shear its pin for an unknown reason. Replaced its pin and all was well. Then the machine set up running 38cal. 125gr TCFP stopped lining up under the orifice plate one stream was hitting the center of the spure plate and the other running down the side of the mold. What a day, gonna fire up the pellet grill put on some “Bacon wrapped Steak bites from Reasors” with a couple jalapenos and spend the evening with the family.